How Solar Charging Time Is Worked Out
Charging time is battery capacity divided by the real input power, with a safety allowance on top. The trick is to use the real input, not the number on the panel.
The pieces
Battery capacity is given in watt-hours (Wh). Energy and power differ. Power is a rate, in watts. Energy is that rate held for a time, and the watt-hour is the basic unit of it1. Your manual states the battery's capacity in Wh.
Panel watts are a ceiling. One maker's guide says a 70 to 85 percent real-input range means the printed wattage is a ceiling, not a promise2. The actual figure shifts as lighting, temperature and load change3.
The method
One maker's table divides battery capacity by real input wattage, then applies a 1.2 ideal-sun factor. It suggests 1.3 to 1.5 for cloud, angle, heat and cable loss2.
A worked example with made-up round numbers
These figures are picked only to make the sums easy. They aren't any product's specs. Say a battery holds 1,000 Wh and one panel is rated at 200 W. At 80 percent, inside the quoted range, the real input is 160 W2.
| Step | Sum | Result |
|---|---|---|
| Base time | 1,000 ÷ 1602 | 6.25 hours |
| Ideal sun, factor 1.2 | 6.25 × 1.22 | 7.5 hours |
| Poorer conditions, factor 1.5 | 6.25 × 1.52 | About 9.4 hours |
The method and factors come from the maker's guide quoted above2. Treat the answer as a range, not a promise.
Two options side by side
| One panel | Two panels | |
|---|---|---|
| Real input in the example | 160 W, from the 200 W panel2 | 320 W, if the station accepts it2 |
| Time at factor 1.2 | 7.5 hours2 | About 3.75 hours2 |
| Check first | The input range | The watt cap, plus voltage or current for the layout |
That second column is arithmetic on the same made-up numbers. It holds only if the station's cap and range allow it2. Halving the time also assumes the panels deliver the same real share of their rating, which the weather decides3.
What the sum leaves out
- The input cap. Panel watts over the station's maximum solar input don't charge it faster2. Use the lower of the two numbers.
- Daylight. The sum gives hours of good sun, not hours on the clock. Light changes through the day.
- Using power while charging. Anything you draw takes from the same supply. Check your manual for what it says about this.
Using it before you buy or plug in
For a rough plan, run the sum twice, once with each factor. If the gap between the two is too wide for your trip, that tells you something. A reading from the display, once the panels are out, beats any estimate. The page on real output against the label explains what moves it.
For a fixed answer for your own model, ask the maker or follow the charging times in your manual.
Where the facts come from
- Kilowatt-hour, Wikipedia
- Solar Charging for Portable Power Stations (2026 guide), Anker SOLIX
- Solar panel, Wikipedia