Skip to content

Solar Connectors and Cables Explained

Last checked 19 November 2026

Solar panels and power stations often use different plugs, so an adapter cable sits between them. One maker's guide gives a common pairing: MC4 on the panel side and XT-60 on the station side1. Other makers may use other plugs, and your manual says which.

The two ends

End What's common Notes
Panel side MC4 connectors, widely used for connecting solar panels2 They need a tool to disconnect, so they don't pull apart by accident2
Station side A plug type chosen by the maker, such as XT-60 in one guide1 The station's manual lists what its port takes
A typical cable chainPanel cable with its own plugAdapter cable that fits both endsStation's solar input port
Panel-side plug, adapter cable, station-side plug.

What MC4 means

The MC in MC4 stands for the manufacturer Multi-Contact, now Stäubli Electrical Connectors. The 4 is for the 4 mm diameter contact pin2. Several other makers sell MC4-type connectors too2. The National Electrical Code and the UL6703 standard for PV connectors specify that connectors have to be from the same type and brand, to avoid the dangers of cross-mating2. Those are US rules. Check what applies where you live.

Not every small panel uses them. Small solar panels used for battery charging and similar tasks may not require special connectors2. Your panel might end in a barrel plug or another type. Look at the plug, then at the manual.

Panel-side cable

Cable for outdoor solar use is normally double-insulated and resistant to UV and higher temperatures. Most cables deteriorate if used outdoors without protection from sunlight2. That's a reason to keep to the cable your maker supplies.

Why to use only what the manual allows

Three plain reasons.

  1. Mixing brands of connector. Product certifications and manufacturer warranties generally require MC4 connectors to be mated to connectors of the same manufacturer and type2. An MC4-style plug from another maker may look the same and still not be covered.
  2. Voltage and plug are separate checks. Third-party panels need a voltage and connector check first. Voltage range and connector type both matter, so check both against the station's solar input specs1. A cable that fits can still carry the wrong voltage.
  3. The cable itself. For a proper seal, MC4s must be used with cable of the correct diameter2. Cable length and connector setup also affect the number you see on the display1.

Connecting and disconnecting

It's very important never to connect or disconnect connectors under load, even on low-voltage systems. An electric arc may form which can melt and seriously damage contact materials, resulting in high resistance and subsequent overheating2. Your manual may set an order for connecting the cable to the station and the panel. Follow it.

Adapter cables, in short

  • Use the cable your maker lists for your model, not one that merely fits.
  • Third-party panels need a voltage and connector check first1.
  • If the manual doesn't name an adapter, ask the maker before you connect anything.

Cables that end in a station's port are the whole job here. Anything that connects to a house circuit, switchboard or transfer switch is licensed electrician work.

Where the facts come from

  1. Solar Charging for Portable Power Stations (2026 guide), Anker SOLIX
  2. MC4 connector, Wikipedia